My Posts

Chance to purchase a Brand New PAM 305 at COST, just arrived, but I find it to close to my PAM 225, so I have decided to sell it at cost. Have original Panerai Boutique bill of sale. Of Course is complete as delivered This message has been edited by valleart on 2009-11-01 20:53:35

If your friend ever tires of the watch please contact me....I'd definately be interested!

Thank you. I greatly appreciate the advice.

I recently bought a blancpain renaissance. I want to get it serviced before beginning to wear it. My question regards sending it to a non Blancpain shop (RGM) versus the blancpain folks in NJ. The price is the same....I'm just looking to find out if I am wiser to send it to blancpain than using anot

Mkvc, Wim Bon and Daniel ? Thank you ALL very much for the insightful and helpful comments. You can be sure my next stop is the Chopard Service center on E63rd Street to start out fresh. Ei8htohms ? You comment struck a nerve with me, so for fun, I did some calculations this morning to show how the

..thickness increases the I term to 56.6 gm-cm2, or a 4:1 advantage over the 15mm microrotor! And of course, if you take the time to create the correct solid model geometry for the rotor in CATIA or AutoCAD, and add thickness around the outer perimeter, the I term will increase. I kept it simple for

Hallo. The 37 mm-version of the Master Control has been produced vom 1994 (?) until may 2005, right? Has anybody an idea, how many units are produced during this time? Is this number correspond with the highest serial number on the back of the watch? Whats the highest number in the forum. I buy my M